We offer two sizes in our SlipSafe™ Circular Floor Signs category. One has a diameter of 9 inches and the other has 17 inches. Both of the sizes are constructed from 18 mil thick anti-skid vinyl with grit surface and permanent adhesive backing. For a 28 inches wide entryway, both the sizes will fit well. While a 9 inch sign would leave plenty of room on either side, a 17 inch sign would cover more than half of the width of the way. However, messages like “Please Wait Here for Your Turn” and “Stand Here for Temperature Check” on the 17 inch floor sign would be much more conspicuous than the 9 inch sign. That said, many customers also buy multiple 9” signs for the entire passage to maintain social distancing between incoming individuals. We recommend bigger sizes for better visibility but it completely depends on your requirements and application area as to which size will work best.
Signs should be mounted at the entrance to make everyone aware about the temperature check requirements. Most facilities have a temperature check station or temperature check booth outside the facility. Temperature screening signs must be posted exactly there to make sure no one enters without getting their temperature checked. Make sure that obstacles like trees or street poles aren’t blocking any of your signs.
Reflective signs work best for parking lots because they offer good visibility even when the lighting is dim. Our portable floor standing signs are a great way to take the sign wherever you want.
There are many sign options for you. Our Notice Sign combines both the policies you want to convey i.e. wear a mask before entry and undergo temperature check. Some signs have an additional requirement - Wash or sanitize your hands before entering. Both the requirements are also included on our ShowCase™ Wall Sign which is available in four designer colors.
Browse through our gallery and find the perfect design that meets your requirements.
Yes, our FloorBoss Temperature Check Required Signs can be used temporarily till the pandemic lasts. After that, you can use any other sign panel (with a different message) for the lightweight A-frame stand. It’s quite easy to swap out sign panels whenever you want to change the message. Similarly, our BigBoss Signs come with Coroplast sign panels that slide into the groves within each frame leg. Sign and Post Kit is another temporary option. Order a different aluminum sign later and reuse the same post and base.
Our Temperature Screening Area ConeBoss sign fits on a standard traffic cone. Once the pandemic situation gets over, you can remove the Cone-top sign and use your cone the way you want. In the same manner, our Stop - Wait To Be Motioned Forward Cone Sleeve (that fits on the cone collar) can be taken off and folded flat when not in use.
Our Temperature Check BigBoss A-Frame signs come with a heavy-duty thermoplastic frame with a contoured profile to deflect wind up to 30+ mph. You can add sand or water (or a mix of both for the heaviest option) to the sign ballast port for greater stability. The printed sign panels offered with the BigBoss Kit are made from 160 mil thick corrugated plastic. Compared to the lightweight FloorBoss Signs, these are much sturdier and ideal for outdoors.
You can also try our sign and post kit which comes with a heavy-duty 23.5 lbs cast iron base with 14 inches diameter and 4 feet tall post.
Most Temperature Check Signs come without sign posts. You can purchase sign posts separately. We do offer a Temperature Check Station Sign and Post Kit. The kit contains an aluminum sign, with a cast iron sign base, one post and attachment hardware kit. Post comes in two parts and when assembled is 4 feet tall and 1.625" in diameter. Posts are easy to move – requiring no drilling for installation.